--%>
Assignment Help - homework help

Number of satellites comprises in the GPS

Determine the number of satellites which are comprises in the GPS and expand it?

E

Expert

Verified

The minimum satellites needed to track your position are three. That is why it is termed as triangulation. Presently, there are thirty two satellites in the GPS system. The exact number differs as old satellites fail or are retired and the new satellites are sent up to restore them.

   Related Questions in Electrical Engineering

  • Q : Designing the IIR filters Explain that

    Explain that why the impulse invariant method is not preferred within the design of the IIR filters rather than the low pass filter?

    		•
  • Q : Input resistance of the op-amp Explain

    Explain why the input resistance of the op-amp is high while its output resistance is low?

    		•
  • Q : Synchronizing inverter using a

    I need some help with a project that I am doing. I am asked to make an inverter that can synchronise itself with a local power supply. The only information provided by my project supervisor was as follows: 1. Look at a method of cr

    		•
  • Q : How do we reduce power consumption in

    How do we reduce power consumption in an embedded system?

    		•
  • Q : Explain VRC Explain the term VRC.

    Explain the term VRC.

    		•
  • Q : Wavelength and Bandwidth Define: a)

    Define: a) Wavelength b) Bandwidth b) Attenuation

    		•
  • Q : Calculate minimum value of input

    The network demonstrated in figure below shows the input of a biomedical amplifier, here a capacitor, C, is utilized to block dc and the input impedance is taken as purely resistive, R.

    Q : Determine an expression for the loaded

    For the loaded base overdrive factor determine an expression, σL of the transistor within the inverter circuit demonstrated below in terms of the circuit parameters. So, write the expression within terms of the unloaded overdrive factor of it, σ

    		•
  • Q : Basic Column Control please see the

    please see the attachment. so, you can see figures. it helps you to write a report only 3 pages. write a short report that analyses the P&ID: i. A one-paragraph introduction. ii. A paragraph about the process. iii. The instruments that are used (describe their tags following the slides). iv.

    		•
  • Q : Generators for generation of electricity

    Explain why the syn. generators are used in the generation of the electricity?

    		•