--%>
Assignment Help - homework help

Meaning of half-duplex and full-duplex communication

Illustrate the meaning of the term half-duplex and full-duplex communication? Describe in brief. 

E

Expert

Verified

Half duplex - both sender and receiver can communicate with one other, however not concurrently....full duplex - similar however simultaneous communication possible.

   Related Questions in Electrical Engineering

  • Q : Find out the impedance of the series

    Find out the impedance of the series R-L network demonstrated in figure below at a frequency of 1 kHz and state this in the form of phase and magnitude. Calculate the current flowing in the network from the source and the individual voltages across the resistor and th

    		•
  • Q : Significance of Cogeneration

    Significance of Cogeneration: It decreases energy costs and green house gas emissions usually by upto two-third. In addition to decreasing in cost, cogeneration too rises resource utilization. It provides major economic and environmental facilities si

    		•
  • Q : Use of Decision table testing Explain

    Explain the situation when Decision table testing is utilized?

    		•
  • Q : Define the ways of communication for a

    Define the ways of communication for a device?

    		•
  • Q : Importance of wait state generator

    Explain the importance of the wait state generator?

    		•
  • Q : Kinds of saturated bipolar logic family

    Explain the kinds of the saturated bipolar logic family?

    		•
  • Q : SISO system and MIMO system Explain

    Explain SISO system and MIMO system?

    		•
  • Q : Basic Column Control please see the

    please see the attachment. so, you can see figures. it helps you to write a report only 3 pages. write a short report that analyses the P&ID: i. A one-paragraph introduction. ii. A paragraph about the process. iii. The instruments that are used (describe their tags following the slides). iv.

    		•
  • Q : Establish output voltage as supply

    A bipolar diode based logic circuit is demonstrated in given figure. Establish the output voltage as the supply voltage, VCC, as well as the circuit parameters for all combinations of input logic levels along with VH = VCC and VL = 0V. Draw waveforms demonstrating the input

    		•
  • Q : What is Genetic algorithm Explain the

    Explain the term Genetic algorithm. Describe it in brief.

    		•