--%>

Fly ball governor in the hydrualic control

How the fly ball governor is used along with the hydraulic control?

E

Expert

Verified

As soon as the turbine speeds up, weights are moved outward through the centrifugal force, resulting in the linkage to open the pilot valve which admits and releases the oil on the either side of piston or on one side of the spring-loaded piston. Steam valves controls the movement of piston.

   Related Questions in Mechanical Engineering

  • Q : Formulating equation of motion Figure

    Figure below shows a reinforced concrete framed building subjected to earthquake ground motion. The floor is rigid with the mass of each floor is shown in the figure. Formulate the equation of motion for this building. Prove that the natural frequenci

  • Q : Formation of Cavitation Explain the

    Explain the reason behind formation of the Cavitation in the Centrifugal Pump and not in the Displacement Pump?

  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Lubricating oil in turbines Except the

    Except the lubrication, explain the other two functions of the lubricating oil in some of the turbines?

  • Q : Undamped single degree of freedom (a)

    (a) The response for an undamped single degree of freedom system under free vibration is given as where ωn is the natural frequency and A and B are unknown that can be determined from the initial conditions. The response 

  • Q : Problem on work of compression A diesel

    A diesel engine operates devoid of a spark plug by using the high-temperature gas produced throughout the compression stage to ignite the fuel. During a typical compression, pure air that is originally at 21 °C and 0.95 bar is reversibly and adiabatically compress

  • Q : Diesel Engine What will happen if the

    What will happen if the gasoline is used within the Diesel Engine, whether the Siesel Engine will work or not?

  • Q : Difference between mill and mill-drill

    Difference between mill and mill-drill: Nowadays numerous manufactures are combining machines; a mill-drill is one of such. This is a combination of a drill and a mill, a mill eliminates stock from material (genera

  • Q : State Concurrent Engineering Concurrent

    Concurrent Engineering has happened primarily as a result of the need to shorten product development times, but improving product quality and reducing product life-cycle costs are important considerations. Some companies have even gone to the extent o

  • Q : Mode Superposition Method Define Mode

    Define Mode Superposition Method in brief?