--%>

Difference between the SCR and diode rectifier

Illustrate the difference between the SCR and diode rectifier?

E

Expert

Verified

Diode is a two terminal device, in SCR, the gate controls the rectifying. SCR is used in High frequency applications however diode is low frequency devices, SCR can be in high temperatures however not diode. 

   Related Questions in Electrical Engineering

  • Q : Plane Waves Normally Incident On

    Problem 1: 1.  This first problem is similar to the first Smith chart example handed out in lecture but there is no perfect electric conductor in this homework problem. Use the Smith chart to solve th

  • Q : Estimate the current flowing from

    A bipolar junction diode contain a uniform cross-sectional region of 2x10-3 cm2 and a doping concentration of 1013 cm-3 in p-type and n-type both materials.  Therefore diffusion properties are Dn = 5 cm2s-1, Ln = 50 µm for (e-

  • Q : Networking Develop traffic flow mapping

    Develop traffic flow mapping and performance requirements for flows.

  • Q : Explain the significant embedded

    Explain the significant embedded processor chips? Answer: The embedded processor chips are as follow: ARM 7 and ARM 9, i 960 and

  • Q : Operating modes of 8255 Explain about

    Explain about the operating modes of 8255?

  • Q : Estimate diffusion current flowing from

    A piece of homogenous semiconductor material that is n-type of length 100µm as well as uniform cross-sectional area of 5x10-4 cm2 having a doping concentration of 1017cm-3. There a linear gradient of carrier concentrat

  • Q : Determine the voltages at each of the

    Sketch up a table demonstrating the states of conduction of each transistor within the TTL gate demonstrated below for all possible logic combinations of steady-state input states and therefore verify its logical function. Differentiate between reverse and forward mod

  • Q : Hamming code Specify the intention of

    Specify the intention of using the hamming code?

  • Q : Designing the IIR filters Explain that

    Explain that why the impulse invariant method is not preferred within the design of the IIR filters rather than the low pass filter?

  • Q : Explain term meta-stability Explain the

    Explain the term meta-stability? When and why it may occur? Explain several ways in order to avoid this?