--%>
Assignment Help - homework help

States the term specification

States the term specification?

Answer: Specification is a bridge in between Architect and Customer. Specification conveys the customer’s requirements. These requirements are properly used during the design process.

   Related Questions in Electrical Engineering

  • Q : VCB at High Transmission System Provide

    Provide the reason for using VCB at the High Transmission System? And not the ACB?

    		•
  • Q : Find out the value of phase for values

    For the electrode amplifier interface model outlined within given figure, illustrate that the maximum phase shift introduced within a signal at the amplifier interface happens at a frequency equivalent to the geometric mean of the pole and zero frequencies as √(

    		•
  • Q : Intersymbol interference meaning What

    What do you mean by the term intersymbol interference?

    		•
  • Q : Find out secondary voltage and number

    A step-down transformer that operating from a 50Hz mains supply of 220 Volt rms, is used to give a decrease voltage to a secondary power supply. The final delivers 400 Watt of power to a load consisting of an equivalent resistance of 10?. The transformer should have a

    		•
  • Q : Calculate the radius of the former of a

    The coil of a relay has 3000 turns wound upon a former having a metal core of relative permeability 8000 and is fed along with a current of 250mA. If the coil have to produce a total internal flux of 0.5Wb and the former include a length of 8cm, calculate the radius o

    		•
  • Q : What do you mean by the term modulation

    What do you mean by the term modulation? And where it is employed?

    		•
  • Q : Difference between the SCR and diode

    Illustrate the difference between the SCR and diode rectifier?

    		•
  • Q : Find out the impedance of the series

    Find out the impedance of the series R-L network demonstrated in figure below at a frequency of 1 kHz and state this in the form of phase and magnitude. Calculate the current flowing in the network from the source and the individual voltages across the resistor and th

    		•
  • Q : Work of ELCB Specify why the ELCB do

    Specify why the ELCB do not work in case N input of the ELCB is not connected to the ground?

    		•
  • Q : Differences between counting semaphore

    What are the differences between counting semaphore and binary semaphore?

    		•