--%>
Assignment Help - homework help

What is change sharing

Explain the Charge Sharing? Specify the Charge Sharing problem during the sampling of the data from Bus?

E

Expert

Verified

Within serially linked NMOS logic, input capacitance of each gate shares the charge with the load capacitance through which the logical levels drastically mismatched rather than that of the desired once. In order to, eliminate this load capacitance should be very high in comparison to input capacitance of gates.

   Related Questions in Electrical Engineering

  • Q : Exemplary applications of Small Scale

    Explain the Exemplary applications of Small Scale Embedded system.

    		•
  • Q : Illustrates buses and units in the

    Illustrates the buses and units in the embedded system hardware?

    		•
  • Q : Estimate maximum tolerable load

    In the capacitively loaded individual transistor inverter demonstrated below, the input voltage is switched abruptly from VCC to 0Volt at time t = 0. In that case the transistor is assumed to function as an ideal change, draw the waveform of the output volt

    		•
  • Q : Explain the software timer Explain the

    Explain the software timer.

    		•
  • Q : What is the dissimilarity between CISC

    What is the dissimilarity between CISC and RISC processors?

    		•
  • Q : Find current in conductor of permanent

    The pole faces of a permanent magnet measure 100 millimeter high by 200mm wide. This is needed to acquire an acceleration of 10ms-2 of a single length of current-carrying conductor that weighs 250gm-1 and is positioned vertically inside the magnetic field, passing horizontal

    		•
  • Q : Question on 8085 instruction Search

    Search internet for the following 8085’s instructions: MOVMVIOUTINHLTNOPFor each instruction answer the following questions: 1- What is the protot

    		•
  • Q : Find out the impedance of the series

    Find out the impedance of the series R-L network demonstrated in figure below at a frequency of 1 kHz and state this in the form of phase and magnitude. Calculate the current flowing in the network from the source and the individual voltages across the resistor and th

    		•
  • Q : Homework on Data Analysis and Solver

    Problem 1:    A calibration curve allows you to relate a certain measured signal to a process variable of interest (say...like the position of a float in a rotameter to fl

    		•
  • Q : Illustrates any two utilizes of VLSI

    Illustrates any two utilizes of VLSI designed circuits?

    		•