--%>
Assignment Help - homework help

Half-duplex communication and full duplex communication

Explain the following terms:

Half-duplex communication and full duplex communication.

E

Expert

Verified

Half-duplex communication:

Transmission arises in both the direction, but not concurrently.

Full duplex communication:

Transmission arises in both the direction, concurrently.

   Related Questions in Electrical Engineering

  • Q : Use of the IRR Explain use of the IRR

    Explain use of the IRR or interrupt request register?

    		•
  • Q : States the Architecture Design of

    States the Architecture Design of embedded system?

    		•
  • Q : Explain requirements and

    Explain the requirements and characteristics of embedded system?

    		•
  • Q : Find out Emitter Saturation and

    An n-p-n transistor contain the given properties are as follows:: Doping Concentrations: Ne = 1018 cm-3, Nb = 1017 cm-3, Nc = 1015 cm-3. 

  • Q : Compute the minimum CMRR in op-amps The

    The instrumentation amplifier demonstrated below is used to monitor the human ECG. Common-mode interference is present that has amplitude 20 times which of the ECG signal. Compute the minimum CMRR needed in the op-amps used when the maximum error in the signal at the

    		•
  • Q : Find out outer dimension required to

    A high-wattage resistor for employ in a dc power supply is formed through depositing Carbon containing a square cross-section to an insulated former containing a cylindrical shape along with a diameter of 2.5 millimetres. A section with the component is demonstrat

    		•
  • Q : Find current in conductor of permanent

    The pole faces of a permanent magnet measure 100 millimeter high by 200mm wide. This is needed to acquire an acceleration of 10ms-2 of a single length of current-carrying conductor that weighs 250gm-1 and is positioned vertically inside the magnetic field, passing horizontal

    		•
  • Q : Determine the impedance of the parallel

    Find out the impedance of the parallel R-C network demonstrated in figure below at a frequency of 150Hz and express this in the form of phase and magnitude. Calculate the current flowing in the network from the source and the individual currents flowing by the resisto

    		•
  • Q : What is impulse response What do you

    What do you mean by the term impulse response?

    		•
  • Q : Wavelength and Bandwidth Define: a)

    Define: a) Wavelength b) Bandwidth b) Attenuation

    		•