--%>
Assignment Help - homework help

Define Cogeneration

Cogeneration is a very high efficiency energy system which generates both electricity (or mechanical energy) and valuable heat from the single fuel source. Cogeneration is some times termed as combined heat and not only produces power however also gives heat for industrial purposes. For illustration a hospital cogeneration plant would generate some of power and all hot water required for its laundry and hot water system from the waste heat it produces.

   Related Questions in Electrical Engineering

  • Q : Generators for generation of electricity

    Explain why the syn. generators are used in the generation of the electricity?

    		•
  • Q : Surge and lightning arrestor State the

    State the difference between the surge arrestor and the lightning arrestor?

    		•
  • Q : Illustrate the Race-around problem

    Illustrate the Race-around problem? Describe how can you repair it?

    		•
  • Q : Determine the values of all tools of

    A buffer circuit is needed to drive the piezoelectric buzzer within a door alarm system. The door mechanism gives a TTL logic well-matched output signal. The buzzer operates from a 12Volt supply and consists of an equivalent load resistance of 80 as well as a small am

    		•
  • Q : Find out the impedance of the series

    Find out the impedance of the series R-L network demonstrated in figure below at a frequency of 1 kHz and state this in the form of phase and magnitude. Calculate the current flowing in the network from the source and the individual voltages across the resistor and th

    		•
  • Q : Basic Neutralizer Control System See

    See the attachment Please write a report which includes:see the figures , and write3 pages 1) a short report that analyses the P&ID 2. A one paragraph introduction. 3. A paragraph about the process. 4. The instruments that are used (describe their tags following the slides). 5. Describe the co

    		•
  • Q : Find out voltage across and current by

    Determine a Thevenin and a Norton Equivalent Model for the circuit demonstrated in figure given below. Find out, using the models, the voltage across and the current by the load resistance that is RL, and the power consumed through the load. Verify both models present

    		•
  • Q : Various modes of mounting a Database

    What are the various modes of mounting a Database along with the Parallel Server?

    		•
  • Q : Define CMRR of recording system and

    The instrumentation amplifier demonstrated below is to be used such as the front-end phase of an ECG recording system. The ECG electrodes consist of a nominal impedance of 20k, along with a mismatch of up to 5k among them. All of the operational amplifiers include a m

    		•
  • Q : How do we reduce power consumption in

    How do we reduce power consumption in an embedded system?

    		•