Flip flops and latches concept

Illustrate the fundamental difference between the Latches and Flip flops?

E

Expert

Verified

Latch works devoid of clock signal; however works with a control signal and it is level triggered device. While flip flop is a 1 bit storage element and works with the clock signal. It’s an edge triggered device. Normally latches are ignored and flip flops are favored.

   Related Questions in Electrical Engineering

  • Q : Difference between the SCR and diode

    Illustrate the difference between the SCR and diode rectifier?

  • Q : Illustrates the some DSP used within

    Illustrates the some DSP used within embedded systems?

    Answer: Some DSP used in the embedded system are:

    TMS320Cxx, SHARC and 56

  • Q : Block floating point representation

    Explain what block floating point representation is and state its advantages? Specify the benefits of the floating point arithmetic?

  • Q : Determine inductor value to accurate

    Find out the Power Factor of the alternating current network demonstrated below, while operating at a frequency of 50Hz. Thus, establish a revised value for the inductor, L that will accurate the Power Factor of the network to unity.

    Q : Find out voltage across and current by

    Determine a Thevenin and a Norton Equivalent Model for the circuit demonstrated in figure given below. Find out, using the models, the voltage across and the current by the load resistance that is RL, and the power consumed through the load. Verify both models present

  • Q : Data mining and data mining techniques

    Explain the term Data mining. Specify different data mining techniques. Also state the aim of Data mining Technique?

  • Q : Determine the voltages at each of the

    Sketch up a table demonstrating the states of conduction of each transistor within the TTL gate demonstrated below for all possible logic combinations of steady-state input states and therefore verify its logical function. Differentiate between reverse and forward mod

  • Q : What is input quantization error

    Explain the meaning of the input quantization error?

  • Q : Mode coupling condition A multimode

    A multimode fiber is employed to couple light into a single mode fiber. Both of the fibers have the similar total diameter. Explain the coupling in brief. Use equations, MATLAB, and so on if necessary.

  • Q : Error correcting methods Specify the

    Specify the types of error correcting methods.

2015 ┬ęTutorsGlobe All rights reserved. TutorsGlobe Rated 4.8/5 based on 34139 reviews.