--%>
Assignment Help - homework help

Cetane Number and Octane Number

Describe the term Cetane Number and the Octane Number?

E

Expert

Verified

Cetane No.- Cetane number is described as the percentage, by volume, of n-cetane within the mixture of n-cetane and alpha methyl naphthalene. It refers to the measure of rating of the CI engine.

Octane No. - Octane number is described as the percentage, by volume, of iso-octane within the mixture of iso-octane and h-heptane. It refers to the measure of rating of the SI engine.

   Related Questions in Mechanical Engineering

  • Q : Life expectancy in Product design

    Life expectancy: This part of the specification will state how long the product should remain in working order provided the customer gives reasonable care and maintenance. Also take into account technological advances and ongoing improvements that wou

    		•
  • Q : Problem related to pressure gauge Water

    Water flowing via the vertical pipe is illustrated below. Compute the required pipe diameter for the smaller pipe,‘d’,  given that the two pressure gauges read similar value.

    Q : Problem on degree of freedom Draw a

    Draw a frequency-response curves for a damped single degree of freedom system subjected to a harmonic excitation under three different damping ratios. System has a natural frequency of ωn as the forcing frequency of the excitation is ω. Describe

    		•
  • Q : Centrifugal Pump and Reciprocating Pump

    Out of Centrifugal Pump or the Reciprocating Pump, which pump is more efficient?

    		•
  • Q : Stop cooling-water flow in turbine

    Whether you stop cooling-water flow through steam condenser when the turbine is slopped?

    		•
  • Q : Undamped single degree of freedom (a)

    (a) The response for an undamped single degree of freedom system under free vibration is given as where ωn is the natural frequency and A and B are unknown that can be determined from the initial conditions. The response 

    		•
  • Q : Conformance to standards in product

    Conformance to standards and specifications: These are standards laid down by national and international authorities. For instance, in Canada there is the Standards Council of Canada (SCC). The United States has many standards bodies including MIL (US

    		•
  • Q : Working environment in Product design

    Working environment: The conditions under which the product is likely to be used, stored, and transported must be specified. The product may have to operate in conditions of extreme temperature, be subject to vibration, radiation; these conditions wil

    		•
  • Q : Product appearance in Product design

    Product appearance: Strongly influenced by the Industrial Designer, the general style? of the product is significant as this will have an influence on materials and manufacturing procedures to be used. The product should be able to grab the customer's

    		•
  • Q : Formulating equation of motion Figure

    Figure below shows a reinforced concrete framed building subjected to earthquake ground motion. The floor is rigid with the mass of each floor is shown in the figure. Formulate the equation of motion for this building. Prove that the natural frequenci

    		•